IEC 61646 PDF

NATIONAL FOREWORD. The Saudi Standards, Metrology and Quality Organization (SASO) had adopted the IEC “Thin-Film Terrestrial Photovoltaic (PV). IECEE Certification & Testing | IEC Standards | IEC | General Information. PDF | Wet leakage is one of the most frequent failure causes in the IEC test sequences [1]. Although the wet leakage test procedure is.

Author: Gabar Kazrazil
Country: Nigeria
Language: English (Spanish)
Genre: Technology
Published (Last): 24 September 2010
Pages: 51
PDF File Size: 11.67 Mb
ePub File Size: 4.14 Mb
ISBN: 831-9-29345-609-5
Downloads: 10847
Price: Free* [*Free Regsitration Required]
Uploader: Tojalabar

Photovoltaic Solar Testing Specifications- IEC , IEC

The second part consists of the requirements for testing. For photovoltaic systems it suggests total insulation, which requires a special insulation of the PV modules according to Safety Class II on the basis of the following requirements:.

Basically, certifications per se do not tell much about the quality of a module. The certifying authority should conduct the same tests on representative samples after the commercial production has started to confirm the quality on the commercially produced item.

Photovoltaic Solar Testing Specifications

Photovoltaic PV module safety qualificationwhich was later issued as the European standard EN almost similar. I have check IEC, but did not find the right information. It is crucial to use PV modules tested against salt mist corrosion certification in case the modules shall be installed near coasts or used for maritime applications. Or do I also need IEC ? Moreover, most certification bodies do not perform regular check ups after the certification has been issued, leaving in theory and praxis many opportunities for bad manufacturers to cut quality corners while on paper iev that certification.

  LCN 4642 PDF

When I buy a solar panel with IEC certification, does it mean the quality of the solar panel is good?

When testing, the prepared and submitted modules undergo HALTs highly accelerated life tests that are not representative of standard real-world conditions. The IEC standard ieec the criteria for the design qualification and type approval of concentrator photovoltaic modules and assemblies suitable for long-term operation in general open-air climates.

Niclas is absolutely correct. An additional test takes the degradation behavior of amorphous silicon due to temperature and irradiance exposure into account.

Solar system installers who do installation in areas with heavy snow should definitely use products with an increased load capacity: When installing ic panels in areas with heavy snow, an increased load capacity of Pa is advisable. Solar installers that are operating in a highly corrosive atmosphere such as near the sea, the resistance of PV panels against the corrosive effects should be checked. I am a test engineer in SPV lab. Nevertheless, depending on where you want to install your panels, the certifications may still be required as per your national requirements or for 61664 in order to apply for FIT.

  HANDBUCH DER AUDIOTECHNIK PDF

Its purpose and methods. This includes all forces of nature:.

Certifications IEC < Regulations < News < Coenergia

Then only the certification should be confirmed. IEC tests at the time of applying for certification. A special certification for Concentrator PV CPV modules is necessary, because the high concentration of the solar irradiance through lenses or mirrors causes higher stress on the equipment. Nowadays many solar manufacturers produce according this ieec. This has been included in the IEC ed. Thank you very much.